top of page

How to Reset Your Pyronix Alarm System

Resetting a Pyronix alarm depends on the specific situation and model you have. Here are some general steps for different scenarios:


After an alarm activation:


Pyronix Euro46 Alarm
Pyronix Intruder Alarm


Enter your user code: This will silence the alarm and display the area that triggered it.

Press the "*" key: This will clear the display and reset the alarm system.

Contact your monitoring center: If you have an alarm monitoring service, they will need to be notified to clear the alarm from their system.


After a power cut:


Wait for the power to fully restore: Don't try to reset the alarm until the power is back on.

Enter your user code: The keypad may display a message about the power cut.

Press "No" if asked to set areas: You don't need to set the alarm again if the power was just out.

The alarm should now be reset: If you see a flashing amber triangle, check your user manual for specific instructions for your model.

Here are some additional resources that you may find helpful:


How to reset your Pyronix system after an alarm: https://m.youtube.com/watch?v=xLaj60zUbZg

How to reset your Pyronix Enforcer alarm after a power cut: https://m.youtube.com/watch?v=zwQjo6JUhFs


Important safety tip:


Never attempt to tamper with your alarm system unless you are qualified to do so. If you are unsure about how to reset your alarm, it is always best to contact your alarm installer or a professional security company.

I hope this information helps! Let me know if you have any other questions.

1 view0 comments

Recent Posts

See All
bottom of page